Maintenance
6-- 24
TDS1000 and TDS2000 Series Digital Storage Oscilloscopes Service Manual
You will need a torque-limiting Torx T-15 screwdriver and pliers for this
procedure.
Removal. To remove the display module, refer to Figure 6--14 and follow these
steps:
1. Remove the power button and rear case using the procedures on page 6--10.
2. Remove the internal assembly from the front case using the procedure on
page 6--17.
3. Disconnect the display cable using the procedure on page 6--19.
4. Disconnect the backlight cable from the power supply module.
5. Remove the four screws attaching the display module to the internal
assembly. The location of the screws as shown in Figure 6--14 will vary
between the color and monochrome displays.
CAUTION. The display shield is attached to the display module. Removing the
shield will destroy the attaching gasket.
Backlight
cable
Power supply
module
Internal
assembly
Main
board
Display
ribbon cable
Display
module
Figure 6--14: Removing the display module
Display Module
To Next Page
Loading...
Need help?
General
