Maintenance
6-- 14
TDS1000 and TDS2000 Series Digital Storage Oscilloscopes Service Manual
You will need a torque-limiting Torx T-15 screwdriver and pliers for this
procedure.
Removal. First, remove the power button and rear case using the procedures on
page 6--10. Then, slide the front feet out of the front case as shown in Figure 6--6.
Installation. Slide the feet into the slots provided in the front case as shown in
Figure 6--6. Use the installation procedures for each module removed to
reassemble the oscilloscope.
Front foot
Figure 6--6: Removing and installing the front feet
Front Feet
To Next Page
Loading...
Need help?
General
