Maintenance
Front-Panel Cable
You will need a t
orque-limiting Torx T-15 screwdriver and pliers for this
procedure.
Refer to the ex
ploded view diagram. (See page 8-8.)
Removal.
1. Remove the f
ront-panel knobs. (See page 8-4.)
(See page 8-6.)
2. Remove the
power button and rear case. (See page 6-10, Rear Case.)
3. Remove the internal assembly. (See page 6-13, Internal Assembly.)
4. Remove the four screws attaching the front panel board to the chassis.
5. Open the clamp to release the front-panel cable.
6. Disconnect the front-panel cable at J202 on the Main board by pulling straight
up from the connector.
7. Disconnect the front-panel cable at J1 on the Front-Panel module.
Installation.
1. Connect the front-panel cable to the Front-Panel module at J1 through the
appropriate slot on the chassis.
2. Twist the cable to keep it from contacting the boards and chassis, and attach
it using the cable tie.
NOTE. Wind up the front-panel cable until it is tight; loops are okay. This keeps
the cable bundle together.
3. Connect the front-panel cable at J202 on the Main board by pushing the cable
straight down into the connector.
4. Install the four screws to attach the front panel module to the chassis.
5. Assemble the oscilloscope by performing the installation procedure for each
module that was removed.
TDS2000C Series Oscilloscope Service Manual 6–17
To Next Page
Loading...
Need help?
General
