TDS3000B Serie s User Manual
G-1
Appendix G: Ethernet Setup
The following sec tions describe how to set up the TDS3000B Series
oscilloscope for network hard copy printing and remote programma-
bility or access. The TDS3000B requires a straight-through 10BaseT
cable with RJ-45 connec tor to connect to a LAN, or a crossover
cable to connect to a PC equi pped with an Ethernet card.
Your Ethernet Network Information
To connect the oscilloscope to the network, you must first obtain
information from your network administrator. For your convenienc e,
use the form on page G--15.
Make two photocopies of the form and send them to your network
administrator to fill in. If you require remote access to the oscillo-
scope for programming or e*Scope access, then have the network
administrator fill in section 1. If you require your oscilloscope to
print screen hard copies to a network printer, then have the network
administrator fill in sections 1 and 2. The administrator can then
return one copy to you and keep the other copy.
NOTE. If the DHCP/BOOTP server assigns a dynami c IP address,
then the value in the Instrument IP Address field may be different
each time you power on the oscilloscope. This is not a problem if you
are mostly sending hard copy to a network print er.
To Next Page
Loading...
Need help?
General
