Appendix G: Ethernet Set up
G-6
TDS3000B Serie s User Manual
4. Push the appropria te bottom and side menu buttons to select the
correct settings for your network printer.
5. Push MENU OFF to clear the screen.
6. Push the Hard Copy button. The oscilloscope sends a hard copy
screen image to the selected network printer. If the printer does
not print the oscilloscope screen, go to page G-- 7 for trouble-
shooting suggestions.
Testing e*Scope
To use the e*Scope fea ture to test your oscilloscope’s Ethernet
connection, do the following steps:
1. On a PC or work station, open your preferred browser program.
2. In the Location or Address field (where you normally enter a
URL), type in the IP address of the TDS3000B Series i nstrument
to which you want to conne ct . For example,
http://188.121.212.107. Do not precede the IP address with any
characters (such as www).
3. Press the Return key. The browser program loads the instrument’s
e*Scope home page. If the e*Scope home page does not display,
refer to page G--7 for troubl eshooting suggestions.
To Next Page
Loading...
Need help?
General
