Telecom Behnke 10 Series Quick Reference Guide

4
Mounting Notes:
When mounting the modules, special attention
must be payed to the aluminium brush-polish-
ing direction – important not only for optical
reasons but also, for example, for the drainage
of water from inside the telephone!
In the case of local external mounting of the
electronics, the module casing is replaced by an
open counterplate for the corresponding front
frame.
Connect the cables in the following order:
1. Buttons
. . . . . . . to the MQS plugs from 1 to 8
marked with a YELLOW ring
2. L
oudspeaker . . . to the plug marked with a
BLUE ring
3. Micr
ophone . . . . to the plug marked with a
WHITE ring
4. Dial pad
. . . . . . 12-pin white jack
5. Camer
a. . . . . . . . 4-pin black jack
Never confuse loudspeaker and microphone
plugs!
Unused cables should be laid with their open
end (plug) pointing downwards inside the
module casing (thus preventing moisture from
entering into the plug). Then place the electron-
ics casing onto the module casing.
1
Assembly (only Series 20!)
Front frame
(with water drainage
slot at the bottom!)
Modules Electronics
casing
Module
casing
Step 1:
Insert modules into the frame
(leave them in the cardboard
surround).
S
tep 3:
Connect cables (see text on the left).
S
tep 2:
Screw module casing
to the frame.
L [B L U E ] = loudspeaker
M [W H I T E ] = microphone
1 to 8 [Y E L LO W ] = buttons 1 to 8
6-pin plug = video
12-pin plug = dial pad
Electronics casing
(with rubber caps at the
cable-entry holes)
Module casing
+ [R E D ] = illumination
Z [Y E L L O W ] = addition
(option)
12-pin plug = dial pad
illumination
Pin assignment of
connecting cable:
Pin assignment of
illumination cable:
SERIES 10 / SERIES 20

Telecom Behnke 10 Series Specifications

General

Brand	Telecom Behnke
Model	10 Series
Category	Intercom System
Language	English