,;2.\-
TEMPTRONIC
v
CORPORATICIN
TP04 100A Operator's Manual
Rev
B:
04/15/98
WARNING
5:
Exposed surfaces in and around the output nozzle and thermal cap of the
system can operate at extremely hot and cold temperatures which are unsafe to touch.
WARNING
6:
The parts contained inside the thermal wand operate at extremely hot and cold
temperatures unsafe to touch. Do not. perform any maintenance inside the thermal wand
assembly until the system is turned off and disconnected. Wait until the thermal wand parts have
reached a safe and stable temperature near ambient.
CAUTION
1:
Some of the packing materials in the TP04100A shipment may be a source for
Electrostatic Discharge (ESD) potential. Do not unpack in the vicinity of
ESD
sensitive
components.
CAUTION
2:
Observe the precautions given on the equipment and within this manual to
prevent damage to the equipment.
CAUTION
3:
Before connecting the TP04100A to its electrical source, check that the
-
(ac)
voltage and frequency to be supplied to the TP04100A are correct for those listed on its data
plate (located on the rear panel of the controller cabinet).
CAUTION
4:
Always hold the thermal wand firmly while positioning or re-positioning the
stand
arm.
CAUTION
5:
Use proper handling and packaging procedures for ESD sensitive circuit boards.
Assume that all circuit boards are the
ESD
sensitive type.
CAUTION
6:
Unauthorized personnel should not remove from the equipment those panels that
are provided for protection and/or cooling andlor require a tool to remove.
CAUTION
7:
Use suitable Clean Dry Air (CDA) compressed air supply for the TP04100A
system to prevent premature fouling of the filterhegulator assembly provided with the system.
Improper air supply quality can lead to possible damage to system internal operating
components.
CAUTION
8:
Properly install, use and maintain the filterlregulator assembly provided with the
TP04100A system. Doing so prevents moisture and/or compressor oils from being introduced
into operating components of the system. If left unchecked, this can cause damage to the system
not covered under warranty.
CAUTION
9:
The two thermal runaway Safety sensors (SF1 and SF2), located on the rear
panel, must remain plugged in for normal operation. If SF2 is not plugged in when the system is
powered On, then an internal fuse must be replaced by qualified service personnel before
normal operation can resume. Only qualified service personnel should disconnect SF1 and/or
SF2.
Page: 8
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
