,A\,
TEMPTRONIC
CORFORATION
Rev. B:
04/15/98
1.
Safety
Precautions
1.1
Scope of Operator's Manual
TP04 100A Operator's
Manual
This manual contains procedures intended for use by operating personnel.
Refer to the
TP04100A
Interface
&
Applications Manual
for general and advanced operation, assembly,
interfacing, interconnecting, preventive maintenance and remote operation parameters. The
TP04100A
Service Manual
is for corrective maintenance procedures and is intended for use
by
service personnel.
1.2.
Safety Precautions For Operating Personnel
WARNING
1:
Operating personnel should perform only the procedures described and
recommended in this manual. Only qualified service personnel familiar with the electrical shock
hazards present inside the equipment should perform disassembly or corrective maintenance of
the equipment.
WARNING
2:
To avoid shock hazard, the equipment must be grounded with an adequate earth
ground in accordance with local electrical codes.
WARNING
3:
The locations of potentially dangerous voltages and other hazards such as hot or
cold surfaces are identified and labeled on the equipment. Be careful to observe these warnings
when installing, operating, maintaining, or servicing the equipment. Observe all warnings given
in this manual.
I
I
Symbols:
A.
Caution,
B.
High Voltage,
C.
Hot Surface,
D.
Cold Surface
WARNING
4:
Make sure to
turn
off the
-
(ac) line power and the compressed air to the
TP04100A
System before attempting to access or service the air filters. Do not perform this
service unless qualified to do so.
Page:
7
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
