3.3 WISP Mode
In this mode, the device functions as a wireless signal
amplifier, ideal for wifi hot spot access and bridging, and provides
NAT and DHCP server features. You only need to config some
simple settings on the device to wirelessly connect to the other
Internet-enabled wireless device without configuring it, so that
multiple users can share the Internet connection via the device. If
you would like more PCs using wired adapters to share this
connection, then simply connect a switch to the device.
Refer to below topology for deploying network devices
involved when using this mode.
5-2 For more info, see section 5-3 hereof
3.4 Client Mode
In this mode, the device is equivalent to a wireless adapter that
enables a PC without an installed wireless network adapter to
connect to a wireless network for Internet connection. Note that
To Next Page
Loading...
Need help?
General
