Tenda PH10 User Manual

5
2.3 WiFi Clone (Optional)
If your router has no WPS button, this function is not available.
If you want to set only one WiFi signal in your house, perform the following procedure:
Step 1 Plug PA7 into a wall receptacle
near your wireless router, wait until
the LED lights up, then press the
Wi-Fi button on PA7.
The LED blinks.
Step 2 Press the WPS button on your
wireless router.

Tenda PH10 Specifications

General

Ethernet LAN	Yes
Certification	CE, FCC
Product color	White
LED indicators	Power, WLAN
Frequency range	2 - 86 MHz
Wi-Fi standards	802.11a, Wi-Fi 5 (802.11ac), 802.11b, 802.11g, Wi-Fi 4 (802.11n)
Antennas quantity	2
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.11a, IEEE 802.11ac, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.3, IEEE 802.3ab, IEEE 802.3u
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Number of adapters included	1 pc(s)
Sustainability certificates	RoHS
WLAN data transfer rates supported	200, 433 Mbit/s
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 90 %
Harmonized System (HS) code	85171800