INS876-1 8/15
3.0 Wireless range test
The wireless range test is available for the first hour after power up or while
the system is in walk test mode – see Premier Elite 8XP-W/32XP-W installation
manual.
With the device in position, press and hold the sensitivity button for 3
seconds.
The LED will flash pink and turn green when a wireless connection is
confirmed.
Should the LED turn red move the device away from metal objects, closer to
the receiver or add more devices to the mesh network.
Once the device leaves commission mode, the device will not show any
status LED’s.
4.0 Mounting
4.1 Device mounting
Select the intended mounting position. The device can be installed in any
mounting orientation.
Open the device cover and remove the PCB using a screwdriver (see figure 4)
To ensure product compliance with EN50131, fix both the detector and
the rear tamper insert to the mounting surface using the following type of
screws:
Head Type: Counter Sunk flat head
Head Diameter: 5.3-6.8mm
Screw Diameter 2.9-3.2mm
Screw length: 15.8-24.5mm
NOTE 1: If the product is mounted on concrete suitable wall plugs should be used.
NOTE 2: If using the magnet, the same screw types should be used for
installation.
Figure 4
To Next Page
Loading...
Need help?
General
