PRE-OPERATING PREPARATIONS 27
6
1. Full open the air vent screw on the
tank cap and release internal pres-
sure.
1. Air vent screw
2. Tank c a p
2. Open the fuel tank cap slowly.
3. Fill the fuel carefully not to over flow.
4. After filling the tank, close the fuel
tank cap.
ENOM00037-A
ENOW00022-A
The engine oil is drained for shipping from
the factory. Be sure to fill the engine to the
proper level before starting engine. (To
properly fill the engine with oil follow the
instructions, See page 61)
1. Filler port
2. Dipstick
1. Upper level
2. Lower level
Use only high quality 4-stroke engine oil
to insure performance and prolonged
engine life.
The SAE oil viscosity 10W-30 or 10W-40
FC-W outboard motor engine oil is rec-
ommended.
You can also use oils that carry the API
rating of SH, SJ, or SL. Select the appro-
priate viscosity, based on atmospheric
temperature, from the chart below.
3. Engine oil recommendation
CAUTION
1
2
ENOF00417-1
SAFE FILL
LEVEL
12 L
NIVEAU
MAXIMUM
ENOF00419-A
To Next Page
Loading...
Need help?
General
