Tomahawk S Series User Manual

Version 1.3
Copyright by
CYTECH GmbH 2008
ENG 5
www.indoorcycling.com
Due to the weight of the indoor cycle, it is recommended that two persons
perform the assembly. Set the cycle in a cleared area and remove all packing
materials; do not dispose of the packing materials until assembly is completed.
1. Identify the rear stabilizer. Orient
the rear stabilizer so the widest parts
of the stabilizer end caps (A) are at
the rear.
While a second person lifts the rear of
the frame, attach the rear stabilizer to
the frame with two M10 x 60mm bolts
(B), four M10 washers, a stabilizer
gasket (C), two plastic washers (D),
and two M10 cap nuts as shown.
2. Orient the front stabilizer so the
widest parts of the stabilizer end caps
(A) are at the front.
While a second person lifts the front
of the frame, attach the front
stabilizer to the frame with two M10 x
60mm bolts (B), four M10 washers, a
stabilizer gasket (C), two plastic
washers (D), and two M10 cap nuts.
It is important that the plastic
washers (D) and PVC gasket (C)
used on front and rear stabilisers
are mounted in the correct
manner and used to prevent
direct contact of metal surfaces
HOW TO ASSEMBLE THE INDOOR CYCLE
USER’S MANUAL – S-SERIES
To avoid damaging the rear stabilizer, do not
over tighten the cap nuts.
To avoid damaging the front stabilizer,
do not over tighten the cap nuts.
1
2
D
C
A
B
D
C
A
B

Tomahawk S Series Specifications

General

Brand	Tomahawk
Model	S Series
Category	Exercise Bike
Language	English