Version 1.3
Copyright by
CYTECH GmbH 2008
Do not over tighten the adjustment
knob. Make sure the pin of the
adjustment knob is fully engaged and
saddle post does not slide while riding.
4. Loosen the M8 bolt on the
lower side of the aluminium
saddle bracket (A) several turns
without removing it. Next, turn
the upper part of the saddle
clamp (B) one quarter of a turn,
and set the rails of the saddle in
the grooves of the lower saddle
clamp. Then, lift the upper saddle
clamp, turn it back to its original
position, and set it on top of the
rails. Finally, firmly retighten the
bolt and make sure that the
saddle is mounted in its most
horizontal position at the middle
of the rail.
3. Turn the rear adjustment knob
(A) counter clockwise and pull the
adjustment knob to insert the
saddle post (B) into the frame.
Next, bring the saddle post to the
desired height, release the
adjustment knob so the pin
engages into the holes of the
saddle post. Then turn the
adjustment knob clockwise to
retighten until it is snug. Then
place the horizontal saddle
support (C) into the slider bracket
and connect it from beneath with
the small adjustment knob (D).
Please don’t adjust the height of
the vertical saddle support
beyond the stop mark to avoid
instability.
To Next Page
Loading...
Need help?
General
