5. Orient the parts needed to
mount the handlebar. Turn the
front adjustment knob (A) counter
clockwise and pull the adjustment
knob to insert the vertical
handlebar post (B) into the frame.
Next, bring the handlebar post to
the desired height, release the
adjustment knob so the pin
engages with the holes of the
vertical stem and turn the
adjustment knob clockwise to
retighten until it is snug.
Please don’t adjust the height of
the vertical saddle support beyond
the stop mark to avoid instability.
6. Set the stop block (C) into the
indicated hole in the lower part of
the handlebar slider. Next, loosen
the adjustment lever handle (D) in
the handlebar slider.
7. Remove the front grub screw (E)
from the upper part of the
handlebar slider (F). Slide the
handlebar onto the handlebar post
until it stops.
Do not over tighten the adjustment knob.
Make sure the pin of the adjustment knob
is fully engaged and handlebar post does
not slide while riding.
To Next Page
Loading...
Need help?
General
