8. Reattach the front grub screw
back into the handlebar until the
end of the grub screw (E) almost
touches the handlebar post.
Finally, slide the handlebar to the
desired position and retighten the
adjustment knob.
7. Identify the right pedal.
Carefully insert the right pedal into
the crank arm, turning by hand
clockwise assuring that it enters
horizontally aligned. Using a
15mm pedal wrench, firmly tighten
the right pedal clockwise into the
right crank arm. Repeat the same
procedure for the left pedal but in a
counter clockwise motion.
The manufacturer recommends
the use of semi loctite to mount
the pedals and to avoid that
pedals become loose while
riding.
8. Make sure that all parts are properly tightened and that the brake pad is
thoroughly soaked with lubricant before the indoor cycle is used. This
precaution will avoid extensive wear on the brake pad. To protect the floor
or carpet, place a mat under the indoor cycle.
To Next Page
Loading...
Need help?
General
