IX. Storage and Transport
（1）Generator storage
If it the generator is to be stored for a long period, follow these steps.
1). Turn the three-in-one switch to "OFF".
2). Open the fuel tank cap, to take out the fuel
filter screen. Pump all fuel in fuel tank into
special fuel tank, and then reassemble the
fuel tank cap back;
3). Start up the engine to burn off the fuel in the
carburetor, and then shut it down;
Tip: Do not connect any electrical equipment.
4). Remove bolts of right enclosure;
5). Unscrew fuel drain bolt on the carburetor, and drain fuel in the carburetor
into special fuel tank.
6). Turn three-in-one switch to "OFF";
7). Tighten fuel drain bolt;
8). Assemble right enclosure back, and tighten bolts;
9). After the engine is completely cooled, switch off the ventilation knob
10). Unscrew the oil dipstick and drain oil in the crankcase. Fill with new oil
to the oil limit, and then assemble oil dipstick.
11). Remove spark plug and pour a bit of clean oil into the combustion
chamber. Rotate the crankshaft a few turns, to distribute oil
evenly, and then reassemble spark plug;
12). Gently pull recoil cord until you feel resistance, allowing both the inlet
valve and exhaust valve to be closed;
13). Place the generator set in a clean and dry area.
(2)Generator transport
• When the generator set is to be transported, it must be ensured that
there is no risk of fuel spilling;
To Next Page
Loading...
Need help?
General