III. Control Functions
（
1）Three-in
-one
combination switch (also referred to as combination
switch)
RUN - After the engine has started, and been left for
5-10 seconds in the CHOKE position, rotate back to
the RUN position for proper function. Do not connect
an electrical load to the generator until the unit has
warmed up for at least 1 minute in the run position. If
the engine is hot, the unit can be started from the
RUN position.
ATTENTION
When the engine is hot, start the generator
in the run position.
(2) Oil indicator (red)
When the oil in the crankcase drops below
the safety line, the oil protection system will
automatically shut down the engine, and the
oil alarm indicator lights up; the engine can
be restarted only after the oil is filled to an adequate oil level.
Tip: In case the engine is unable to be started, turn the combination switch
to "RUN" position, and then pull startup handle. If oil indicator flashes a few
seconds, the oil volume is insufficient, fill oil and restart it.
(3) Overload indicator (red)
When the overload indicator lights up, the generator has detected that the
output of connected electrical equipment has been overloaded, causing
the frequency converter to be overheated or the AC voltage to rise. At this
moment, the AC protector will stop, to protect the generator from the
OFF - The ignition circuit is OFF and the engine will be unable to run.
CHOKE - When performing a cold start, rotate the switch to the
CHOKE position and pull the recoil until the engine starts. Be sure to
check for proper oil levels.
To Next Page
Loading...
Need help?
General