Tornado BR 18/1 MW User Manual

8
(1) Bottom handle
(2) Machine body
(3) Component housing
(4) Solution tank
(5) Top handle and solution cable
(6) Handle LH & RH
(7) Brush shafts (2)
(8) Screws & washers
(9) Cable retainer
(10) Power cord
(11) Dirty water tank
(12) Handle knobs
1. The Tornado BR 18/1 MW ships with the handle dismantled. To assemble, verify that all of the parts listed are included.
2. Remove the black band, which holds the bottom handle with the machine body, while holding the bottom handle.
Warning! Since the bottom handle is spring loaded, care must be taken when removing the hook to avoid sudden
springing back, leading to possible injury to personnel.
Unpack
(4)
(1)
(2)
(3)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
Preparing for Use
How it Works
How it Works
1. Cleaning liquid in the solution tank is sprayed to the oor.
The counter rotating brushes scrub the oor and also
throw the dirty water on the conveyor drum. The front
brush does most of the scrubbing and drying. The rear
brush completes the scrubbing and collects the remaining
water o the oor.
2. A blade tted to the recovery tank wipes the drum and
collects the dirty water.
The purpose of these caps is to distinguish between dierent brushes when the
machine is used in dierent area. This just helps the operator easily identify the
brushes to avoid cross contamination.
Important - Should the machine fail to operate, contact the supplier from whom you purchased the
machine.

Tornado BR 18/1 MW Specifications

General

Brand	Tornado
Model	BR 18/1 MW
Category	Scrubber
Language	English