23
third gear when in High range. Key is installed with teeth
pointing downward. Push key in to turn. Key is removable
in either position.
Light Switch
Toggle switch (Fig. 16) to activate headlights. Push to turn
lights “ON”.
Oil Pressure Warning Light
Light glows (Fig. 16) if engine oil pressure drops below a
safe level while engine is running. If light flickers or
remains ON, stop vehicle, turn off engine and check oil
level. If oil level was low, but adding oil does not cause
light to go out when engine is restarted, turn engine off
immediately and contact your local TORO distributor for
assistance.
To check operation of warning lights:
1. Apply parking brake.
2. Turn ignition key to “ON”, but do not start engine. The
oil pressure light should glow red. If light does not
function, either a bulb is burned out or there is a
malfunction in the system which must be repaired.
Note: If engine was just turned off, it may take 1 to 2
minutes for light to come on.
Fuel Gauge
Shows amount of fuel in tank. Operates only when ignition
switch is in “ON” position (Fig. 16).
2
5
4
6
1
3
Figure 16
1. Light switch
2. Oil pressure warning light
3. Fuel gauge
4. Tachometer (Optional)
5. Horn
6. Choke
Tachometer (Optional)
Indicates engine RPM (Fig. 16).
Horn Button
Pressing button activates horn (Fig. 16).
Choke
To start a cold engine, close the carburetor choke by pulling
the choke control (Fig. 16) out to the ON position. After the
engine starts, regulate the choke to keep the engine running
smoothly. As soon as possible, open the choke by pushing
in the choke control to the OFF position. A warm engine
requires little or no choking.
Passenger Hand Hold
On dashboard (Fig. 17).
1
2
Figure 17
1. Passenger hand hold 2. Storage compartment
Seat Adjusting Lever
The seats can be adjusted fore and aft for operator comfort
(Fig. 18).
1
Figure 18
1. Seat adjusting lever
To Next Page
Loading...
Need help?
General
