Toro Groundsmaster 7210 User Manual

Figure 5
Right Side Shown
1. Roll bar
3. Hairpin cotter pin
2. Pin
2. Raise the roll bar to the upright position and
install the tw o pins and secure them with the
hair pin cotter pins ( Figure 5 ).
Note: If y ou m ust lo w er the roll bar , push
the bar forw ard to reliev e pressure on the
pins , remo v e the pins , lo w er the bar slo wly ,
and secure it with the pins so that it does not
damag e the hood.
Step
4
Checking the Tire Pressure
No Parts Required
Procedure
T he tires are o v er inflated for shipping . T herefore ,
release some of the air to reduce the pressure . T he
cor rect air pressure is 15 psi (103 kP a) in the rear
tires and 25 psi (172 kP a) in the caster wheels .
19

Toro Groundsmaster 7210 Specifications

General

Horsepower	24.8 hp
Drive System	Hydrostatic
Number of Blades	3
Fuel Capacity	12 gallons
Deck Type	7-Gauge High-Strength Steel
Blade Tip Speed	18, 000+ ft/min
Turning Radius	Zero
Cutting Height	1.0" (2.5 cm) to 5.0" (12.7 cm) in 0.5" (1.3 cm) increments