13
RUNNING A PROGRAM
To manually start a single Program or a number
of Programs:
1 Select RUN PROG. on the Control Dial. A
Program number will be displayed and OFF
will be flashing.
2 Press to change to ON.
3 Press to select another of the six
programs and press to change to ON.
4 Repeat step 3 until all desired Programs have
been turned on.
5 Press to run the test program. The
watering cycles that you have programmed for
the selected Programs will begin immediately,
regardless of the Start Time and Watering
Days programmed.
The controller will run all the activated programs
sequentially.
If a Water Budget has been programmed, it will
be applied to the watering times.
The test can be stopped temporarily for 10
minutes:
1 Press to pause irrigating. A countdown
clock will show the time remaining before the
irrigation will resume.
2 Press at any time, to restart the process
To Next Page
Loading...
Need help?
General
