Maintenance
45
Washing
Underside of Mower
After each use wash the underside of the mower to
prevent grass build-up for improved mulch action and
clipping dispersal
1. Park the machine on a hard level surface,
disengage the power take off (PTO) and turn the
ignition key to “OFF” to stop the engine.
2. Attach hose coupling to the end of the mower
washout fitting, turn water on high (Fig. 25).
3. Lower the mower to the lowest height-of-cut.
4. Sit on the seat and start the engine. Engage
power take off (PTO) and let mower run for one
to three minutes.
5. Disengage the blade, power take off (PTO) and
turn the ignition key to “OFF” to stop the
engine. Wait for all moving parts to stop.
6. Turn the water off, remove hose coupling from
the washout fitting.
Note: If the mower is not clean after one
washing, soak and let stand for 30
minutes. Then repeat process again.
7. Run mower again for one to three minutes to
remove excess water
.
1
2
3
m–3113
Figure 25
1. Washout
port
2. Coupling
3. Hose
POTENTIAL
HAZARD
• A broken or missing washout fitting could
expose you and others to thrown objects or
blade contact.
WHAT CAN HAPPEN
• Contact with thrown debris or blade
contact will cause injury or death.
HOW TO AV
OID THE HAZARD
• Replace broken or missing washout fitting
immediately, before using nower again.
• Plug any hole(s) in mower with bolts and
locknuts.
• Never put your hands or feet under the
mower or through openings in the mower.
To Next Page
Loading...
Need help?
General
