Workman GTX Electric Page 5 -- 7 Chassis
Suspension and Steering (continued)
Problem Possible Cause
Front end shimmies. Front wheel lug nuts are loose.
Front wheel alignment (toe--in) is incorrect.
Front wheel bearings are loose or worn.
Tie rod ends are loose or worn.
Steering shaft bearings or joints are loose or worn.
Bushings in spindle or A--arm are loose or worn.
Steering is hard. Tire pressure is low or uneven between tires.
Steering components are binding or damaged.
Front wheel alignment (toe--in) is incorrect.
Steering rack assembly is damaged or worn.
Vehicle pulls to one side when not
braking.
Tire pressure is low or uneven between tires.
Front wheel alignment (toe--in) is incorrect.
Steering or suspension component may be damaged.
Brakes
Problem Possible Cause
Brake pedal goes to the floor. Brake fluid level in master cylinder is low.
Brake fluid leak exists at master cylinder, brake hose or brake
caliper.
Brake pads are excessively worn.
Brake master cylinder is faulty.
Brake pedal is spongy. Air is trapped in brake lines.
Transaxle bearings are loose or damaged.
Brake master cylinder is faulty.
Chassis
To Next Page
Loading...
Need help?
General
