Toro Z-Master User Manual

3
Installation
Loose Parts
Note: Use the chart below to identify parts used for assembly when unit is to be installed on traction unit.
DESCRIPTION QTY. USE
Bagger baf fle–left
Bagger baf fle–right
Discharge baf fle–left
Discharge baf fle–right
Carriage bolt 5/16”–18 x 3/4” (19 mm)
Locknut 5/16”–18
Chute latch
Screw 10–24 x 1/2” (13 mm)
Locknut 10–24
Locking pin 3/8 x 6” (152 mm)
Spring
Spring bracket
Chute bumper
Bolt 1/4–20 x 3/4” (19 mm)
Flange locknut 1/4–20
1
1
1
1
10
10
1
2
2
1
1
1
1
2
2
Install baf fles, latch and bumper to mower
Blower assembly
Carriage bolt 3/8–16 x 1” (26 mm)
Bolt 3/8–16 x 2-3/4” (70 mm)
Idler assembly
Spacer
W
asher 3/8” x 7/8” (9 x 22 mm)
Flange locknut 3/8–16
Spring
Bolt 5/16–18 x 1-1/4” (32 mm)
Nut 5/16–18
Flange locknut 5/16–18
Interlock switch bracket assembly
Bolt 3/8–16 x 3/4” (19 mm)
1
1
1
1
1
1
2
1
1
1
1
1
1
Install blower, idler and switch assemblies to
traction unit

Toro Z-Master Specifications

General

Brand	Toro
Model	Z-Master
Category	Lawn Mower Accessories
Language	English