21
Basic operation
Note:
• If the built-in tuner does
not receive anything (e.g.
if no antenna is
connected) during TV
operation, the TV will
change to standby mode
after approx. 15 minutes.
•Press TV/RADIO to
switch between the three
service categories: TV,
Radio, and Data.
Channel selection
Use the number buttons 0-9. For example:
• CH 2: Press 0 and within 2 seconds, press 2. The TV will switch to CH 2.
• CH 29: Press 2 and within 2 seconds, press 9. The TV will switch to CH 29.
(1) Press CH to select a channel. This takes approx. 2 seconds to switch from one
channel to another. Only channels saved in the TV and are active can be displayed.
Skipped channels will not appear (see page 19).
The Channel List shows a list of all receivable programmes. They are located in channels 1
to 99 for ATV mode and 1 to 999 for DTV mode.
(2) Press ENTER/CH LIST to display the Channel List.
(3) Press to select a desired channel, and then press ENTER/CH LIST to display
the selected channel.
(4) Press EXIT/CANCEL to exit.
Toggle between the list of TV, Radio, and Data services (DTV mode only)
(1) Press TV/RADIO to switch between the TV, Radio, and Data mode.
(2) If you press ENTER/CH LIST when you are in Radio mode, the Channel List menu
will display the list of Radio services.
If you wish to view the list of Data services without exiting the current menu, press
TV/RADIO once.
If you wish to view the list of TV services without exiting the current menu, press
TV/RADIO again.
QuickView
Press CH RTN ZOOM to go back to the last selected channel.
Volume adjustment
Press VOL +/– to adjust the volume. The volume level indicator shows the current volume, and
will disappear after 4 seconds of inactivity.
Mute
Press MUTE to turn off the sound. The TV/DVD’s sound will be turned off and Mute will
appear on-screen. Press MUTE again or VOL
+/– to turn the sound on.
To Next Page
Loading...
Need help?
General
