Adjusting the picture
Adjusting the picture quality
You can adjust the picture quality to your personal preferences,
including the brightness, contrast, color, tint, and sharpness. The
qualities you choose will be stored automatically in the PICTURE
menu's MEMORY mode so you can recall them at any time.
To adjust the picture quality:
1. Press MENU, then press 4 or _ to display the PICTURE menu.
2. Press Jk or V until the item _ouwant to adjust is highlighted.
COUTRAST _0
COLOR 2S
TINT _
SHARPNESS
RESET
I_ :SgLECT _.1 :AOJ UST
3. Press _ or I_ to adjust the level.
BRIGHTNESS darker lighter
CONTRAST lower higher
COLOR paler deeper
TINT reddish greenish
SHARPNESS softer sharper
4. Press EXIT to return to normal viewing.
Resetting your picture adjustments
The RESET function returns your picture quality adjustments to the
following factory settings:
Brightness ............ center (25) Tint ......................... center (0)
Contrast .................. max (50) Sharpness ............ center (25)
Color .................... center (25)
To reset your picture adjustments:
1. Press MENU, then press 4 or I_ to display the PICTURE menu.
2. Press A or V to highlight RESET, and then press _'.
P_LUAJ_
BmGHTNESS 2_
CONTRAST Se
COLOR _S
TINT
SHARPNESS 2S
Sleep
Menu
Exit
Setting the sleep timer
You can use the sleep timer to automatically turn off the TV at a set time.
To set the sleep timer:
Repeatedly press SLEEP on the remote control to set the length of
time until the TV turns off. The clock will increase 10 minutes for each
press of the SLEEP button (0h00m, 0hl 0m, ...1h50m, 2h00m.) After
the sleep timer is programmed, the display will appear briefly every
ten minutes to remind you that the sleep timer is operating.
To confirm the sleep timer setting:
Press SLEEP one time. The remaining time will be momentarily displayed.
To cancel the sleep timer:
Repeatedly press SLEEP until the display turns to 0h00m.
3O
J3W41121A(E) P22-30 30 14/03/2006, 3:38 PM
To Next Page
Need help?
General
