8
Set up
Preparation
Basic Operation
Advanced Operation
Reference Section
Preparing the remote control for use
Your TV remote control can operate your TV together with most VCR models and cable TV converters, even if they are
different brands.
If you have a Toshiba VCR, your TV remote control is already programmed to operate it (see page 10).
If you have a non-Toshiba VCR and/or cable TV converter, you must first program your remote control so it will operate the
other equipment (see pages 11–13).
Installing the remote control batteries
1 Slide the battery cover off the back of the remote control.
Caution:
Dispose of batteries in a designated disposal
area. Do not throw batteries into a fire.
Do not mix battery types or combine used
batteries with new ones.
Remove dead batteries immediately to prevent
battery acid from leaking into the battery
compartment.
If you do not intend to use the remote control for
a long time, remove the batteries.
Note:
If your Toshiba TV remote control does not
operate all of the features of your VCR or cable
TV converter, you may need to use the remote
control that came with your other equipment.
Press and slide to remove.
2 Install two “AA” size batteries, making sure to match the + and – signs on
the batteries to the signs on the battery compartment.
3 Slide the battery cover back onto the remote control until the lock snaps.
Preparation
Preparation
To Next Page
Loading...
Need help?
General
