18
CARE/HANDLING OF THE MEDIA
• Do not store the media for longer than the manufactures recommended shelf life.
• Store media rolls on the flat end, do not store them on the curved sidesas this might flatten that
side causing erratic media advance and poorprint quality.
• Store the media in plastic bags and always reseal after opening. Unprotected media can get dirty
and the extra abrasion from the dustand dirt particles will shorten the print head life.
• Store the media in a cool, dry place. Avoid areas where they would beexposed to direct sunlight,
high temperature, high humidity, dust or gas.
• The thermal paper used for direct thermal printing must not have specifications which exceed
Ca++ 800 ppm, Na+ 800 ppm, K+ 800 ppmand Cl– 600 ppm.
• Some ink used on pre-printed labels may contain components which shorten the print head's
product life. Do not use labels pre-printed with ink which contains hard substances such as
carbonic calcium (CaCO3)and kaolin (Al2O3, 2SiO2, 2H2O).
For further information please contact your local distributor or your media manufacturer.
CAUTION!
Be sure to read carefully and understand the Supply Manual. Use only media that meets specified
requirements. Use of non-specified media may shorten the head life and result in problems with
bar code readability or print quality. All media should be handled with care to avoid any damage to
the media or printer. Read the following guideline carefully.
ATTENTION!
Rassurez-vous d'avoir lu attentivement et compris le manuel d'approvisionnement. Utilisez
uniquement le média qui remplit les critères spécifiés. L'utilisation de média non spécifié pourrait
raccourcir la vie de la tête et les problèmes
de lecture des codes à barres ou la qualité d'impression en résulteront. Tout média doit être
manipulé avec attentionpour éviter un dommage quelconque au média ou à l'imprimante. Lisez
attentivement les directives dans cette
To Next Page
Loading...
Need help?
General