Toshiba BC Series User Manual

56 / 73
Copyright © 2019 Toshiba Teli Corporation, All Rights Reserved. http://www.toshiba-teli.co.jp/en/
D4296087A
● Normal Shutter / TriggerMode = OFF
In this mode, the electronic shutter can be handled by the value in the register.
If shutter speed is longer than readout time, the frame rate changes according to shutter speed.
● Randum Trigger Shutter / TriggerMode = ON
An image is captured at the desired timing using trigger signal input.
External trigger (Hardware trigger) signal from CameraLink I/F (CC1) and software trigger from control
command are available (Fix mode). Operation point of HardwareTrigger is at the edge of trigger signal, and
active edge polarity is able to change by register setting (High active / Low active).
Note that Random Trigger Shutter will cause a delay between trigger signal and start of exposure.
- Fix mode (TriggerSequence0)
The exposure time is determined by Exposure Time setting.
TRIG
Exposure
FVAL
LVAL
DVAL
T1 T3T2
DATA OUT
PixelFormat
HighFramerateMode
T1 [μs]
T3 [μs]
ShortExposureMode
OFF
ON
OFF
ON
Mono8
OFF
12.4
28.6
565.7
566.7
ON
10.6
26.0
565.1
566.0
Mono10/Mono12
OFF/ON
16.7
34.3
566.4
567.3
* T1 and T3 are typical value
* T2 = electronic shutter setting value

Toshiba BC Series Specifications

General

Brand	Toshiba
Model	BC Series
Category	Digital Camera
Language	English