Telephone Administration Reference:
Toshiba DP5000-Series Digital Telephones
16 of 20
Telephone Administration Reference:
To Initialize a DP5000-series telephone:
1. Press 3+6+9+Hold (simultaneously)
2. Press MODE softkey
3. Press Msg key
4. Press Hold
5. Press Volume Up
6. Press Msg key
7. Press Hold
8. Go off-hook then on-hook to exit programming mode.
This will reset all the programming mode options settings back to the factory default.
The DP5000-series telephones can be programmed in the same manner as the DKT3200-series
telephones with the following considerations:
DP5130-SDL LCD Keystrip Setup
eManager version V5.10A05 or later is required.
Assign Keystrip Label Resources to device
1. Log into eManager
2. Select Advanced Configuration > Station > Assignments
3. From the station list on the right hand side of the screen, choose the extension number to change.
4. Click on the DKT tab
FB 03: Keystrip Button Quantity should be changed to 10
FB 39: LARGE LCD PHONE should be changed to DP5130.
5. Click on the Submit button.
Note To change this DN to another DP5000-series telephone or to a DKT, with a key type other than 10
use the following steps.
1. Change FB 39 to “Not DP5130”
2. Press Submit.
3. Change FB 03 to a value other than 10.
4. Press Submit.
Program Keystrip Labels
1. Log into eManager
2. Select Advanced Configuration > Station > Assignments
3. From the station list on the right hand side of the screen, choose the extension number to change.
4. Click on the Key tab
5. Click on the button to be setup
6. Choose the feature to be applied from the feature list on the right-hand side.
To Next Page
Loading...
Need help?
General
