Telephone Administration Reference:
Toshiba DP5000-Series Digital Telephones
17 of 20
7. A Webpage Dialog box pops up that allows the feature to be customized
8. Key Strip Label will be the name that appears on the LCD label, it can be setup with an easy to
remember identifier.
9. Click OK
10. Click Submit.
LM5110 LCD Keystrip Setup
eManager version V5.10A05 or later is required.
Assign Keystrip Label Resources
1. Log into eManager
2. Select Advanced Configuration > Station > Assignments
3. From the station list on the right hand side of the screen, choose the extension number which
corresponds to the LM module to be labeled.
4. Click on the DKT tab
5. FB 40: ADM1-LCD KEYSTRIP should be changed to LM5110.
If more than one LM module is attached change FB41 to LM5110. Up to two LM modules can be
connected.
6. Click Submit.
Note To remove an LM module (ADM1 or ADM2)
1. Change FB 40 (ADM1) or FB 41 (ADM2) to “Not LM5110”
2. Click on Submit.
3. Change FB 4 to “One” or “None” as appropriate.
4. Click on Submit.
Program Keystrip Labels
1. Log into eManager
2. Select Advanced Configuration > Station > Assignments
3. From the station list on the right hand side of the screen, choose the extension number to change.
4. Click on the Key tab
5. Click on the button to be setup under LCD Key ADM1 or LCD Key ADM2 if more than one LM module
is connected.
6. A Webpage Dialog box pops up that allows the button to be customized
7. Enter the Extension number to be assigned to the button.
8. Key Strip Label will be the name that appears on the LCD label, enter an easy to remember identifier.
9. Click OK
10. Click Submit.
To Next Page
Loading...
Need help?
General
