86
Getting Started
Turning off the computer
5.375 x 8.375 ver 2.3
For information on how to use and configure Hibernation
mode see “Using and configuring Hibernation mode” on
page 89.
Standby mode
The Standby command places the computer into a power-
saving mode. Standby holds the current state of the computer
in system memory (RAM) so that, when you restart the
computer, you can continue working from where you left off.
Factors to consider when choosing Standby:
❖ While in Standby mode, the computer uses some main
battery power.
❖ The Standby command does not store unsaved
information on your hard disk. You should save your
work before putting your computer on Standby.
❖ Restarting from Standby takes less time and consumes
less main battery power than restarting from turning off
the computer or using Hibernation mode.
❖ When starting up again, the computer returns to the mode
in which you left it, including all open programs and files
you were using.
If you power down using the Standby command and the main
battery discharges fully, your unsaved information will be lost.
Be sure to save your work first.
For information on using Standby, see “Using and
configuring Standby mode” on page 91.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
