Toyota CAMRY 2006 User Manual

’06Camry_U (L/O 0507)
309
2006 CAMRY from July ‘05 Prod. (OM33708U)
Low level Full level
Add oil O.K. Too full
2.4 L 4- cylinder (2AZ- FE) engine (type A)
Low level Full level
Add oil O.K. Too full
2.4 L 4- cylinder (2AZ- FE) engine (type B)
Low level Full level
Add oil O.K. Too full
3.0 L V6 (1MZ- FE) and 3.3 L V6 (3MZ- FE)
engines
With the engine at operating tempera-
ture and turned off, check the oil level
on the dipstick.
1. To get a correct reading, the vehicle
should be on level ground. After turning
off the engine, wait a few minutes for
the oil to drain back into the bottom of
the engine.
2. Pull the dipstick out, hold a rag under
the end and wipe it clean.
3. Reinsert the dipstick—push it in as far
as it will go, or the reading will not be
correct.
4. Pull the dipstick out and look at the oil
level while holding a rag under the
end.
CAUTION
Be careful not to touch the hot ex-
haust manifold.
NOTICE
Be careful not to drop engine oil on
the vehicle components.
If the oil level is below or only slightly
above the low level line, add engine oil
of the same type as already in the en-
gine.
Remove the oil filler cap and add engine
oil in small quantities at a time, checking
the dipstick. We recommend that you use
a funnel when adding oil.
The approximate quantity of oil needed to
raise the level between low and full on the
dipstick is indicated as follows:
2.4 L 4- cylinder (2AZ- FE) engine
1.0L(1.1qt.,0.9Imp.qt.)
3.0 L V6 (1MZ- FE) and 3.3 L V6 (3MZ-
FE) engines
1.5L(1.6qt.,1.3Imp.qt.)
Checking the engine oil level

Toyota CAMRY 2006 Specifications

General

Brand	Toyota
Model	CAMRY 2006
Category	Automobile
Language	English