158
2-1. Driving procedures
L/C200_U_(L/O_0708)
Turn signal lever
n Turn signals can be operated when
The “ENGINE START STOP” switch is in IGNITION ON mode.
n If the indicators flash faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned
out.
Right turn
Left turn
Move and hold the lever
partway to signal a lane
change
The right hand signal will flash
until you release the lever.
Move and hold the lever
partway to signal a lane
change
The left hand signal will flash
until you release the lever.
ITY21C013
To Next Page
Loading...
Need help?
General
