147
2-2. Charging
2
Plug-in hybrid system
Refer to the following table and carry out the appropriate correction
procedure.
â– The power source indicator on the CCID (Charging Circuit
Interrupting Device) does not illuminate, even though the
plug is connected to an external power source.
When charging cannot be carried out
When charging does not start, even though the normal proce-
dure is followed, check each of the following items.
If a message is shown on the multi-information display, also refer
to P.152.
When charging cannot be carried out
Likely cause Correction procedure
Plug is not properly connected to
outlet
Check that the plug is properly con-
nected to the outlet.
Power is out
After power is restored, carry out the
charging procedure again.
Building breaker is tripped and
power is cut off
Check that the breaker is connected
and if there is no malfunction, check
if the vehicle can be charged through
another outlet.
If charging is possible, the first outlet
may have a malfunction. Contact the
building or facility manager, or an
electrician.
Short circuit between CCID
(Charging Circuit Interrupting
Device) and plug
Immediately stop charging and con-
tact your Toyota dealer.
To Next Page
Loading...
Need help?
General
