279
5-2. Driving procedures
5
Driving
5-2.Driving procedures
1 Check that the AC charging
cable is disconnected.
(P.123)
2 Pull the parking brake switch
to check that the parking
brake is set. (P.290)
The parking brake indicator will
come on.
3 Check that the shift lever is
set in P.
4 Firmly depress the brake
pedal.
and a message will be dis-
played on the multi-information dis-
play.
If it is not displayed, the hybrid sys-
tem cannot be started.
5 Press the power switch
shortly and firmly.
When operating the power switch,
one short, firm press is enough. It is
not necessary to press and hold the
switch.
If the “READY” indicator turns on,
the hybrid system will operate nor-
mally.
Continue depressing the brake
pedal until the “READY” indicator is
illuminated.
The hybrid system can be started
from any power switch mode.
6 Check that the “READY” indi-
cator is illuminated.
The vehicle will not move when the
“READY” indicator is off.
■ Power switch illumination
According to the situation, the
power switch illumination operates
as follows.
● When driver’s door or front pas-
senger’s door is opened, the
power switch illumination illumi-
nates.
● When the power switch is in OFF
and depressing the brake pedal
with carrying the electronic key on
your person, the power switch illu-
mination blinks.
● When the power switch is in ACC
or ON, the power switch illumina-
tion illuminates.
● When the power switch mode is
changed from ACC or ON to OFF,
the power switch illumination illu-
minates for a certain amount of
time. Afterwards, the power switch
illumination turns off.
■ If the hybrid system does not
start
● The immobilizer system may not
have been deactivated. (P.72)
Contact your Toyota dealer.
● If a message related to start-up is
shown on the multi-information
Power (ignition)
switch
Performing the following
operations when carrying
the electronic key on your
person starts the hybrid
system or changes power
switch modes.
Starting the hybrid sys-
tem
To Next Page
Loading...
Need help?
General
