TP-Link TL-SG1016 User Manual

II
FCC STATEMENT
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to pro-vide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not in-stalled and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
¾ Reorient or relocate the receiving antenna.
¾ Increase the separation between the equipment and
receiver.
¾ Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
¾ Consu
lt the dealer or an experienced radio/ TV techni cian for
help.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including
interference that may cause undesired operation.

TP-Link TL-SG1016 Specifications

General

MAC address table	8000 entries
Maximum data transfer rate	2 Gbit/s
Supported data transfer rates	10/100/1000 Mbps
10G support	-
Full duplex	Yes
Networking standards	IEEE 802.3, IEEE 802.3ab, IEEE 802.3u, IEEE 802.3x
Dimensions (WxDxH)	440 x 180 x 44 mm
Power requirements	100 - 240V / 50-60Hz
Networking features	Gigabit Ethernet
Connectivity technology	Wired
Switch type	Unmanaged
Power connector	DC-in jack
Basic switching RJ-45 Ethernet ports quantity	16
Stackable	No
Certification	FCC, CE, RoHS
Product color	Brown
LED indicators	Status
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 90 %