TP-Link TL-SG1016 User Manual

III
Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority
to operate the equipment.
CE Mark Warning
This is a class B product. In a domestic environment, this
product may cause radio interference, in which case the user
may be required to take adequate measures.
Package Contents
The following contents should be found in your package:
¾ One TL-SG1016/TL-SG1024 Switch
¾ One power cord
¾ This User Guide
¾ Rubber footpads for Desk-mount
¾ Rack-mount kit for installing the switch in a 19-inch rack
Note:
Make sure that the package contains the above items. If any of
the listed items are damaged or missing, please contact with
your distributor.
Safety Notices
Do not use this product near water. Avoid using this product during
an electrical storm. Do not place heavy objects on the switch.

TP-Link TL-SG1016 Specifications

General

MAC address table	8000 entries
Maximum data transfer rate	2 Gbit/s
Supported data transfer rates	10/100/1000 Mbps
10G support	-
Full duplex	Yes
Networking standards	IEEE 802.3, IEEE 802.3ab, IEEE 802.3u, IEEE 802.3x
Dimensions (WxDxH)	440 x 180 x 44 mm
Power requirements	100 - 240V / 50-60Hz
Networking features	Gigabit Ethernet
Connectivity technology	Wired
Switch type	Unmanaged
Power connector	DC-in jack
Basic switching RJ-45 Ethernet ports quantity	16
Stackable	No
Certification	FCC, CE, RoHS
Product color	Brown
LED indicators	Status
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 90 %