Note:
This function is available only in Windows 7 and Windows 8.
In Soft AP mode, the adapter will work as an AP.
Suppose that only one computer in your house can access the Internet for various reasons like
only one WLAN port is available on your wired broadband router, however, other
wireless-capable devices also want to share the Internet. Then the adapter can be configured
as an AP under the Soft AP mode, saving you the trouble of having to get a separate access
point or a router.
With this feature, a computer can use a single physical wireless adapter to connect as a client
to a hardware access point while at the same time acting as a software AP allowing other
wireless-capable devices to connect to it.
To switch to this mode, right-click on the utility icon in your system tray and select Switch to
Soft AP mode.
Figure 5-1
Or from the Advanced page of the utility, tick ON under the Soft AP mode as shown in the
following figure. Click OK when prompted to confirm the setting.
Figure 5-2
34
To Next Page
Loading...
Need help?
General
