24
PTAC-SVX004A-EN
key to switch on the unit and CANCEL the AUTO
SWITCH ON state.
NNoottee:: The +/- buttons are used to increase/decrease
value settings for either time or temperature.
Refer to the sub-sections below about how to
use the +/- buttons to set temperature values.
– ++ BBuuttttoonn; press this button to set increased
temperature values when unit is ON.
Continuously press and hold this button for
more than 2 seconds until °F (°C) displays. In
AUTO Mode, the temperature can not be set up,
but this button can send the signal.
Temperature ranges are between 61°F and 86°F
(16°C and 30°C).
NNoottee:: To switch between Fahrenheit and Celsius,
press and hold the -- aanndd MMOODDEE keys
simultaneously while in SSWWIITTCCHH OOFFFF
state.
– -- BBuuttttoonn; .press this button to set decreased
temperature values when unit is ON.
Continuously press and hold this button for two
seconds to decrease the temperature value. The
temperature adjustment is unavailable in AUTO
Mode, but this button can send the signal.
• LLOOCCKK; to LOCK and UNLOCK (default) the keypad,
press and hold the -- oorr ++ aanndd MMOODDEE keys
simultaneously while in either SSWWIITTCCHH
OONNSSWWIITTCCHH OOFFFF states. The unit show the LOCK
icon when in LOCK Mode, in which case, the lock
icon flashes three (3) times upon operation of any
key. The LOCK icon does not display when the unit
is in UNLOCK Mode.
Changing Batteries in the Remote
Control
The remote requires two (2) AAA, 1.5V batteries.
1. From the back side of the remote, gently press
down on the battery cover and slide it towards the
bottom of the unit.
2. Remove the old batteries from the battery
compartment.
3. Insert two (2) new batteries into the battery
compartment. Ensure the batteries poles match the
polarity when inserting them into the battery
compartment: + to + and - to -.
NNoottee:: Only use the recommended battery type. If
the remote has not been used for an
extended period of time, check the expiration
date on the batteries or check for battery
leakage.
4. Slide the battery cover back onto the remote until
the tab clicks.
BBEESSTT PPRRAACCTTIICCEE::
Check your local city/state for proper recycling
procedures. A battery is an electrochemical device with
the ability to convert chemical energy to electrical
energy to provide power to electronic devices.
Batteries contain heavy metals such as mercury, lead,
cadmium, and nickel, which can contaminate the
environment when batteries are improperly disposed
of. When incinerated, certain metals might be released
into the air or can concentrate in the ash produced by
the combustion process. Batteries may produce the
following potential problems or hazards:
• Pollute the lakes and streams as the metals
vaporize into the air when burned
• Contribute to heavy metals that potentially may
leach from solid waste landfills.
• Expose the environment and water to lead and acid.
• Contain strong corrosive acids. May cause burns or
danger to eyes and skin.
OOppeerraattiioonn
To Next Page
Loading...
Need help?
General