LOWER THE LIFT
1. Raise the lift until the latch clears.
2. Pull both latch releases.
WARNING ALWAYS RELEASE BOTH SIDES
3. Press the lever at the power unit to lower the lift.
SAFETY PROCEDURES
z Never allow an unauthorized person to operate lift. Thoroughly train new employees
in the use and care of the lift.
z Caution-the power unit operates at high pressure.
z Remove passengers before raising vehicle.
z Prohibit unauthorized people from being in shop area while lift is in use.
z Total lift capacity is 9000lbs with 2500lbs per arm pad.
z Prior to lifting vehicle, walk around the lift and check for any objects that might
interfere with the operation of: lift, safety latches, tools, air hoses or shop equipment.
z When approaching the lift with a vehicle, center the vehicle between the columns so that
the tires will clear the swing arms easily. Slowly drive the vehicle up between the posts.
Have someone outside the vehicle guide the driver.
z Always lift vehicle using all four arms.
z Never use lift to raise one end or one side of vehicle.
z Raise vehicles about 3’ and check stability by rocking.
z Prior to lowering vehicle, walk around the lift and check for any objects that might
interfere with the operation of lift, safety latches, tools, air hoses or shop equipment. Swing
the arms out of the path and slowly drive the vehicle out. Have someone outside the vehicle
guide the driver.
ALWAYS LOCK THE LIFT BEFORE GOING UNDER THE VEHICLE.
NEVER ALLOW ANYONE TO GO UNDER THE LIFT WHEN RAISING OR
LOWERING.
MAINTENANCE SCHEDULE
The following periodic maintenance is the suggested minimum requirements and minimum
intervals of accumulated hours or monthly period, which ever comes sooner. If you hear a
noise or see any indication of impending failure –
then cease operation immediately –
and inspect, correct and/or replace parts as required.
11
Floor Plate/Overhead Style Lifts
To Next Page
Loading...
Need help?
General
