7
Troubleshooting
TROUBLESHOOTING
Problem
NoAC output is available,
but engine is running.
Cause
I. Circuit breaker is open.
2. Poor connection or defective cord set.
3. Connected device is bad.
Solution
I.
2.
3.
4. Fault in generator. 4.
I. Short circuit in a connected load. I.
When loads are 2. Generator isoverloaded. 2.
connected, engine runs
good but bogs down. 3. Engine speed istoo slow. 3.
4. Shorted generator circuit. 4.
Engine shuts down during Out of gasoline. Fill fuel tank.
operation.
Engine lacks power. Load is too high. See "Don't Overload Generator".
Reset circuit breaker.
Check and repair.
Connect another devicethat isin
good condition.
Contact Authorized Service Facility.
Disconnect shorted electrical toad.
See"Don't Overload Generator".
Contact Authorized Service Facility.
Contact Authorized Service Facility.
m
To Next Page
Loading...
Need help?
General
