Troy-Bilt 47329 User Manual

Section 1: Safety 5
Maintenance and Storage
1. Before performing any maintenance or
adjustments, shut the engine off, wait for
all moving parts to come to a complete
stop, and disconnect and secure the spark
plug wire away from the spark plug. Allow
unit to cool before working near it or plac¬
ing a storage cover over it.
2. Store unit where children will not have
access to it. Always disconnect the spark
plug wire and prevent it from touching the
spark plug before storing unit.
3. Be sure unit is stored in an area where
gasoline vapors (fumes) from unit cannot
reach an open flame or spark.
4. Keep the chipper blade sharp.
5. For seasonal storage: Disconnect
spark plug wire and move wire away from
spark plug. Let engine cool before storing.
Refer to the Engine Owner’s Manual for
proper engine storage information.
6. C heck all nuts, bolts and screws at fre
quent intervals for proper tightness to be
sure equipment is in safe working
condition.
Safety Decals
For your safety and the safety of others,
various safety and operational decals are
located on your unit (see below).
Keep the decals clean and legible at all
times. Contact your local service dealer or
the factory for replacements if any decals
are damaged or missing.
Refer to the Parts List in this Manual for
decal locations, part numbers and order¬
ing instructions.
NOTE: All decals are shown at a reduced
size.
44 DANGER
i
ROTATING CUTTING BLADES.
BLADES CUT IN INCH PROM
DISCHARGE SCREEN!
TO AVOID SERIOUS PERSONAL INJURY WHILE
MACHINE IS RUNNING:
• KEEP HANDS AND FEET OUT OF
DISCHARGE OPENING!
• KEEP AWAY FROM DISCHARGE AREA!
A DANGER
ROTATING CHIPPER
BLADE WILL CAUSE
SERIOUS PERSONAL
INJURY. DO NOT
OPERATE UNLESS
CHIPPER CHUTE IS
BOLTED IN PLACE.
44 WARNING
TO AVOID A FIRE HAZARD, KEEP LEAVES, GRASS AND OTHER COM-
BUSTABLE MATERIALS AWAY FROM HOT ENGINE AND MUFFLER!
ik DANGER
ROTATING CUTTING BLADES.
KEEP HANDS AND FEET OUT
OF INLET AND DISCHARGE
OPENINGS WHILE MACHINE
IS RUNNING TO AVOID
SERIOUS PERSONAL INJURY.
NO HANDS BELOW THIS LINE
V_y
4k WARNING
DO NOT START ENGINE UNLESS BELT
COVER IS ATTACHED. Fsilurs to Comply
Could Rosult In Porsonol injury From Moving
Bolt And Pulloys. Soo Ownsr's Manual For
Full Safety And Maintenance I ns truction s .
Ref. Description and Location
A Operating Instructions Decal — Located on forward portion of hopper
B Danger Decal — Located on forward portion of machine, above discharge area
C Danger Decal — Located on left side of mainframe, in front of belt cover
D Danger Decal — Located on right side of mainframe
E Danger Decal — Located on right side of mainframe, at bottom of chute
F Fire Hazard Decal — Located on the handlebars
G Danger Decal — Located on the inside of the chipper chute
H Warning Decal — Located under belt cover

Troy-Bilt 47329 Specifications

General

Brand	Troy-Bilt
Model	47329
Category	Chippers/Shredders
Language	English