EasyManuals Logo
Home>Troy-Bilt>Snow Blower>5024

Troy-Bilt 5024 User Manual

Troy-Bilt 5024
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
Problem Cause Remedy
Engine fails to start Choke not in ON position.
Spark plug wire disconnected.
Fuel tank empty or stale fuel.
Engine not primed.
Faulty spark plug.
Safety key not in ignition on engine.
1.
2.
3.
4.
5.
6.
Move choke to ON position.
Connect wire to spark plug.
Fill tank with clean, fresh gasoline.
Prime engine as instructed in “Operating
Your Snow Thrower”.
Clean, adjust gap, or replace.
Insert key fully into the switch.
1.
2.
3.
4.
5.
6.
Engine runs erratic Engine running on CHOKE.
Stale fuel.
Water or dirt in fuel system.
Carburetor out of adjustment.
1.
2.
3.
4.
Move choke lever to OFF position.
Fill tank with clean, fresh gasoline.
Drain fuel tank. Refill with fresh fuel.
Contact an authorized Service Center.
1.
2.
3.
4.
Engine overheats Carburetor not adjusted properly.1. Contact an authorized Service Center.1.
Excessive vibration Loose parts or damaged auger.1. Stop engine immediately and disconnect
spark plug wire. Tighten all bolts and nuts. If
vibration continues, have unit serviced by an
authorized Service Center.
1.
Loss of power Spark plug wire loose.
Gas cap vent hole plugged.
1.
2.
Connect and tighten spark plug wire.
Remove ice and snow from gas cap. Be
certain vent hole is clear.
1.
2.
Unit fails to propel itself Drive control cable in need of adjustment.
Drive belt loose or damaged.
1.
2.
Adjust drive control cable. Refer to
Maintenance and Adjustments section
Replace drive belt.
1.
2.
Unit fails to discharge snow Chute assembly clogged.
Foreign object lodged in auger.
Auger control cable in need of adjustment.
Auger belt loose or damaged.
Shear pin(s) sheared.
1.
2.
3.
4.
5.
Stop engine immediately and disconnect
spark plug wire. Clean chute assembly and
inside of auger housing with clean-out tool
or a stick.
Stop engine immediately and disconnect
spark plug wire. Remove object from auger
with clean-out tool or a stick.
Refer to Auger Control Test.
Refer to Maintenance section.
Replace with new shear pin(s).
1.
2.
3.
4.
5.
Troubleshooting
9
24

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Troy-Bilt 5024 and is the answer not in the manual?

Troy-Bilt 5024 Specifications

General IconGeneral
BrandTroy-Bilt
Model5024
CategorySnow Blower
LanguageEnglish

Related product manuals