CHAPTER 5: CARE & MAINTENANCE
RUNNING BELT ALIGNMENT (continued):
If the running belt is too far to the left side:
• Locate the belt adjustment bolts in the rear end caps of the
treadmill. (To determine left and right, stand at the rear of the
treadmill and face the display).
• Using the appropriate size Allen wrench or socket turn the
LEFT adjustment bolt clockwise ¼ turn.
• Turn the treadmill on and start the belt at 3mph keeping off
the unit.
• Allow 2 minutes for the belt to adjust itself.
• Repeat the above steps if additional adjustment is necessary.
TENSIONING THE RUNNING BELT:
If there is a slipping or jerking sensation when running on the treadmill, the running belt may require tightening. In most
cases the belt has stretched from use. Tensioning the belt takes a few simple adjustments. If you are unsure about this
procedure, call the TRUE Service Department.
• Locate the belt adjustment bolts in the rear end caps of
the treadmill.
• Using the appropriate size Allen wrench or socket turn
BOTH adjustment bolts clockwise ¼ turn.
• Turn the treadmill on and start the belt and check if the
slipping continues. Repeat the above steps if additional
adjustment is necessary.
For commercial use over 20 hours per week, TRUE recommends lubricating every three months.
• Loosen the belt adjustment bolts in the rear end caps.
• Lift the belt and apply the lubricant to the center of the deck.
• Center and re-tension the belt using the directions above.
• Walk on the treadmill at 2MPH for about 60 seconds to
spread the lubricant evenly through the belt and deck.
*Please contact your dealer or visit www.truefitness.com to obtain the
proper lubricants.
Truefitness.com / 800.426.6570 / 636.272.7100 35
To Next Page
Loading...
Need help?
General
