17
TE200/TE210/TE300/TE310 Series
Bar Code Printer Service Manual
5. Disconnect the stepping motor
connectors on the main board.
6. Remove/replace the stepping motor
module.
7. Reassemble the parts in the reverse
procedure.
3.4 Replacing the Gap Sensor Module
1. Please refer to the section 3.1 to
remove the print engine.
2. Turn the print engine upside down
and remove the screw as indicated.
3. Remove/replace the gap sensor
(receiver).
Screw on Gap Sensor
(receiver)
Gap sensor (receiver)
(Fixed position, shift 4 mm to right)
To Next Page
Loading...
Need help?
General
