TSC TTP-343 series User Manual

TSC AUTO ID Technology Co., Ltd. 159 Copyright 2009 All Rights Reserved.
TDP-245 Plus series
0~15
0~15
X
TTP-246M/344M series (non usb)
0~63
0~63
X
TTP-246M/344M series (usb)
0~31
0~31
X
TTP-246M Plus
0~7
0~3
X
TTP-248M series
0~255
0~255
X
TTP-2410M series
0~7
0~3
X
TDP-643 Plus series
0~15
ON/OFF
X
TDP-643R Plus series
0~255
ON/OFF
X
TTP-342 series
0~15
ON/OFF
X
TTP-342M series
0~15
ON/OFF
X
TTP-342 Plus series
0~255
ON/OFF
X
TTP-344M Plus series
0~7
0~3
X
TTP-346M series
0~7
0~3
X
TTP-384M series
0~7
0~3
X
TTP-644M series
0~7
0~3
X
M23 series
0~255
0~255
X
TTP-225 series
0~31
0~3
X
TDP-225 series
0~31
0~3
X
Note: When in “SET HEAD OFF” mode, the function “SET GAP AUTO”
doesn’t work even the printer head is opened and closed, but it can work when
power on the printer.
Example
The example below is operated in DOS environment via the parallel port connection to
setup the label size, gap distance and sensor sensitivity.
C:\>COPY CON LPT1<ENTER>
SIZE 4,2.5<ENTER>
GAP 0.12,0<ENTER>
SET GAP 1<ENTER>
<CTRL><Z><ENTER>
C:\>
Note: <ENTER> stands for keyboard “ENTER” key. In the above example, please
press “ENTER” key instead of typing <ENTER> in the above example. <CTRL>
stands for keyboard “Ctrl” key.
Troubleshooting:
Press the FEED key to test. Does printer stop at the same position on each label without
the error light blinking? If not, adjust the setting to a larger number. When adjusting
this setting, begin from 0 and then on to higher values incrementally.
See Also

TSC TTP-343 series Specifications

General

Brand	TSC
Model	TTP-343 series
Category	Label Maker
Language	English