TSC TTP-345 User Manual

i
COPYRIGHT DECLARATION ..............................................................................1
COMPLIANCES................................................................................................1
1. Introduction.........................................................................................1
2. Getting Started....................................................................................1
2.1 Unpacking and Inspection............................................................1
2.2 Equipment Checklist.....................................................................1
2.3 Printer Parts...................................................................................3
3. Setup....................................................................................................4
3.1 Setting Up the Printer ...................................................................4
3.2 Loading the Ribbon.......................................................................4
3.3 Loading Label Stock.....................................................................6
3.4 External Label Roll Mount Installation (Option) .........................8
3.5 Peel-off Module Installation (Option)...........................................9
3.5.1 Loading the Paper in Peel-off Mode....................................12
3.6 Cutter Module Installation (Option) ...........................................14
3.6.1 Loading Label in Cutter Mode .............................................17
3.7 Instructions to Top Cover Operation.........................................18
3.8 Diagnostic Tool ...........................................................................21
3.8.1 Start the Diagnostic Tool......................................................21
3.8.2 Printer Function (Calibrate sensor, Ethernet setup, RTC
setup………)...................................................................................22
3.9 Setting Ethernet by Diagnostic Utility (Option) ........................23
3.9.1 Using USB interface to setup Ethernet interface...............23
3.9.2 Using RS-232 interface to setup Ethernet interface ..........24
3.9.3 Using Ethernet interface to setup Ethernet interface........25
3.10 Install Memory Card..................................................................27
4. Power on Utilities..............................................................................29
4.1 Ribbon and Gap/Black Mark Sensor Calibration......................29
4.2 Gap/Black Mark Calibration, Self-test and Dump Mode...........29
4.3 Printer Initialization.....................................................................33
4.4 Set Black Mark Sensor as Media Sensor and Calibrate the
Black Mark Sensor............................................................................34
4.5 Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor
34
4.6 Skip AUTO.BAS...........................................................................34
5. Maintenance......................................................................................36
Contents

TSC TTP-345 Specifications

General

Brand	TSC
Model	TTP-345
Category	Printer
Language	English