Getting Started 2-7
Using t h e Integ r a l Therm a l P r inter
The side-mounted integral thermal printer is standard on most models to
print manually, automatically after each test is completed, or whenever
the alarm function is activated (see Print Setup Screen and Print
Schedule Screen on the System Setup Screen).
Printer paper has a colored strip printed on the last few feet of each roll to
indicate time to change the paper roll.
When installing a new roll of paper, the tag end should be from the
bottom of the roll and pulled through the printer door.
The printer has an LED indicating that the printer is ready.
There is also a feed button
to allow a manual feed of the paper
before tearing it off. To tear off, pull steadily down on the paper from one
side of the serrated edge to the other.
To Next Page
Loading...
Need help?
General
